About the Double Trouble Bracket
The DT bracket is made from 1/8" steel. The quality can be seen in all aspects, from how it is bent and welded, to the precision of each slot and hole. It is designed with all trappers in mind, both land and water. It fits foot holds, sizes 1 1/2 and 2, as well as conibears up to 160. Continue reading for a few of the many ways it can be used in a set!
Setting a Conibear
There are many ways you can use the DT bracket to set a conibear trap.
It can be used to set in a run or with a baited set. Anything from a cut down wooden post, fiber glass pole, or rebarr may be used,. The bolt in the back can be used to securely tighten the bracket into place. The traps may be set both horizontally and vertically with this method. When setting them vertically, all you need to do is insert a screw into the point of the v so you post stays in place while leaving room for the conibear to connect.
Easy as ...
1. Set your trap
2. Line trap up with the slots on the bracket. Make sure chains are out of the way.
3. Retrieve cacth and repeat!